Curing method of wet curtain

Use of wet curtain

1. Water control. The water supply should make the wet curtain evenly drenched. The water volume can be controlled by adjusting the water supply valve.

2. The wet curtain paper pad is not evenly wet or dry. Adjust the water supply valve to control the water volume or a larger power pump or a larger diameter water supply pipe. Flush the pool, water pump inlet, filter, spray water pipe, etc. in time.

3. Water leakage treatment. Water droplets splashing away from the wet curtain: Check whether the water supply is too large; whether there is a damaged wet curtain with broken edges or "flashing" on the edge. Water leakage at the joints: After stopping the water supply, add silica gel.

4. Water quality control. Keep the water source clean, the pH of the water is between 6-9. Clean the pool regularly and clean the water supply system. To keep the quality of the water in good condition, in order to prevent the growth of algae or other microorganisms on the surface of the wet curtain, 3-5ppm chlorine or bromine can be added to the water for short-term treatment. The concentration during continuous treatment is 1 ppm.

Maintenance of wet curtain:

1. Daily maintenance: stop the fan after 30 minutes of stopping the pump, and dry the wet curtain. After the system stops running, check whether the water in the water tank is empty.

2. Rodent control: in the season when the wet curtain is not used, rodenticide can be sprayed on the lower part of the wet curtain by installing anti-rodent nets. (The company's wet curtain does not contain rat-proof nets)

3. The wet curtain cleans the scale and algae on the surface of the wet curtain. Use a soft brush to clean up and down, avoid horizontal brushing. (You can brush a part first to check whether the wet curtain can withstand the brush.) Then only start the water supply system to rinse the scale and algae on the surface of the wet curtain. (Avoid using steam or high-pressure water to rinse the wet curtain)